Install ten cage nuts in the desired slots of the rack: three cage nuts in the front part of each
Step 6.
cabinet post, and two cage nuts in the rear part of each cabinet post.
R
Attach the frame to the rack by using ten spacer cage nuts, and screw ten M6 pan head
Step 7.
screws - four in the front part of the rack, and 6 in its rear part. The recommended torque is
6.55-7.35 Nm. See
Place the frame in the cabinet.
Step 8.
Rev 2.2
Figure 40: Sliding the Frame Sliders into the Rails
Figure 41: Installing the Cage Nuts
Figure 41.
Mellanox Technologies
F
Installation
48