Table of Contents
Advertisement
Before attempting a remote (for example, SSH) connection to the system, check the mgmt0
Step 5.
interface configuration. Specifically, verify the existence of an IP address. To check the cur-
rent mgmt0 configuration, enter the following command:
Check the software version embedded in your system, using the command 'show version'.
Step 6.
Compare this version to the latest version that can be retrieved from Mellanox support site.
To upgrade software, please refer to the Onyx (MLNX-OS) User Manual.
Rev 2.2
r-qa-sit-switch01 (config) # show interfaces mgmt0
Interface mgmt0 status:
Comment:
Admin up:
yes
Link up:
yes
DHCP running:
yes
IP address:
192.168.1.100
Netmask:
255.255.255.0
IPv6 enabled:
yes
Autoconf enabled:
no
Autoconf route:
yes
Autoconf privacy:
no
DHCPv6 running:
no
IPv6 addresses:
1
IPv6 address:
fe80::202:c9ff:fe63:b55a/64
Speed:
1000Mb/s (auto)
Duplex:
full (auto)
Interface type:
ethernet
Interface source:
physical
MTU:
1500
HW address:
00:02:C9:63:B5:5A
RX bytes:
968810197
RX packets:
10982099
RX mcast packets:
0
RX discards:
0
RX errors:
0
RX overruns:
0
RX frame:
0
r-qa-sit-switch01 (config) #
Mellanox Technologies
TX bytes:
1172590194
TX packets:
10921755
TX discards:
0
TX errors:
0
TX overruns:
0
TX carrier:
0
TX collisions: 0
TX queue len:
1000
Installation
60
Hide quick links:
Advertisement
Table of Contents
