Figure 22: Mounting The Outer Rails Into The Rack; Figure 23: Attaching The Inner Rails To The Switch; Figure 24: Securing The Chassis In The Inner Rails - Mellanox Technologies Spectrum SN2740 Hardware User Manual

If cable accommodation is required, route the power cable and/or Eth cable through either
Step 3.
of the outer rails.
Attach left and right inner rails (A+B) to the switch sides, by gently pushing the switch
Step 4.
chassis' pins through the slider key holes, until locking occurs.
Secure the chassis in the inner rails by screwing the 2 flat head Phillips screws (F) in the
Step 5.
designated points with a torque of 1.5±0.2 Nm.
Slide the switch into the rack by carefully pushing the inner rails into the outer rails installed
Step 6.
on the rack.
Rev 2.2

Figure 22: Mounting the Outer Rails into the Rack

Figure 23: Attaching the Inner Rails to the Switch

Figure 24: Securing the Chassis in the Inner Rails

Mellanox Technologies
Installation
35