Remove the blank cover from the selected slot in the frame, and mount the system by slid-
Step 9.
ing its mounting blades into the frame. Repeat this step to install an additional system in the
other side of the frame, if needed.
Tighten the capture nuts to secure the system in the frame. The recommended torque on the
Step 10.
right screw is 3.0-3.36 Nm while on the left screw recommended torque is 0.89-0.98 Nm.
Rev 2.2
Figure 42: Attaching the Frame to the Rack
Do not remove both of the blank covers at the same time. When no system is installed,
at least one of them should be present to support the frame's partition.
Figure 43: Sliding the System's Blades in the Rails
Mellanox Technologies
Installation
49