Figure 16: Installing The Cage Nuts; Figure 17: Attaching The Brackets To The Rack - Mellanox Technologies Spectrum SN2740 Hardware User Manual

While your installation partner is supporting the system's weight, perform the following steps:
Mount the system into the rack enclosure, and attach the brackets installed on the system to
Step 5.
the rack's posts. Secure the brackets to the rack's posts by inserting four M6 screws in the
designated cage nuts, as described in
Slide the two blades into the left and right rails, and adjust them to fit your rack's depth. Use
Step 6.
four M6 screws (D) to fix the blades into the rack. Do not tighten the screws yet.
Rev 2.2

Figure 16: Installing the Cage Nuts

While each rack U (unit) consists of three holes, the cage nut should be installed verti-
cally with its ears engaging the top and bottom holes only.

Figure 17: Attaching the Brackets to the Rack

Mellanox Technologies
Figure 17. Do not tighten the screws yet.
Installation
30