holes, the cage nut should be installed vertically with its ears engaging the top and bottom
holes only. See
While your installation partner is supporting the system's weight, perform steps 3, 4 and 5:
On the rear side of the cabinet, install the two blades (B) in the selected rack unit, using four
Step 3.
M6 screws (C). Do not tighten the screws yet. See
Slide the two blades into the left and right rails, and adjust them to fit your rack's depth. Use
Step 4.
four M6 screws (D) to fix the blades into the rack. Do not tighten the screws yet. See
Figure
Rev 2.2
Figure
31.
Figure 31: Installing the Cage Nuts
Figure 32: Attaching the Rails to the Rack
33.
Mellanox Technologies
Figure
32.
Installation
41