Mellanox Technologies Spectrum SN2740 Hardware User Manual page 100

14. Equipment Disposal
15. Local and National Electrical Codes
16. Installation Codes
17. Battery Replacement
18. UL Listed and CSA Certified Power Supply Cord
19. Installation codes
20. Interconnection Of Units
Rev 2.2
Disposal of this equipment should be in accordance to all national laws and regula-
tions.
This equipment should be installed in compliance with local and national electrical
codes.
This device must be installed according to the latest version of the country national
electrical codes. For North America, equipment must be installed in accordance to the
applicable requirements in the US National Electrical Code and the Canadian Electri-
cal Code.
Warning: Replace only with UL Recognized battery, certified for maximum abnormal
charging current not less than 4mA
There is a risk of explosion should the battery be replaced with a battery of an incorrect
type.
Dispose of used batteries according to the instructions.
For North American power connection, select a power supply cord that is UL Listed
and CSA Certified, 3 - conductor, [16 AWG], terminated with a molded plug rated at
125 V, [13 A], with a minimum length of 1.5m [six feet] but no longer than 4.5m.
For European connection, select a power supply cord that is internationally
harmonized and marked "<HAR>", 3 - conductor, minimum 1.0 mm2 wire, rated at
300 V, with a PVC insulated jacket. The cord must have a molded plug rated at 250 V,
10 A.
This device must be installed according to the latest version of the country national
electrical codes. For North America, equipment must be installed in accordance to the
applicable requirements in the US National Electrical Code and the Canadian Electri-
cal Code.
Cables for connecting to the unit RS232 and Ethernet Interfaces must be UL certified
type DP-1 or DP-2. (Note- when residing in non LPS circuit)
Mellanox Technologies 100