Cable Installation; Figure 44: Sn2700, Sn2100 And Sn2010 Qsfp Cable Orientation - Mellanox Technologies Spectrum SN2740 Hardware User Manual

2.6

Cable Installation

All cables can be inserted or removed with the unit powered on.
To insert a cable, press the connector into the port receptacle until the connector is firmly seated.
The LED indicator, corresponding to each data port, will light when the physical connection is
established. When a logical connection is made, the relevant port LED will turn on.
To remove a cable, disengage the locks and slowly pull the connector away from the port recep-
tacle. The LED indicator for that port will turn off when the cable is unseated.
For full cabling guidelines, ask your Mellanox representative for a copy of Mellanox Cable Man-
agement Guidelines and FAQs Application Note.
For more information about port LEDs, refer to
Rev 2.2
Do not force the cable into the cage with more than 40 newtons / 9.0 pounds / 4kg
force. Greater insertion force may cause damage to the cable or to the cage.
The SN2410 system includes ports of different types. Figure 43 below does not apply
to the SFP28 ports. See Figure

Figure 44: SN2700, SN2100 and SN2010 QSFP Cable Orientation

Mellanox Technologies
"Port LEDs".
50.
Installation
50