Table of Contents
Advertisement
Objet350 User Guide
Inhalation
Vapors from printing materials can be irritating to the respiratory system. If
respiratory irritation occurs, expose the victim to fresh air immediately.
➢ If the victim has stopped breathing, perform artificial respiration or
➢ Seek medical attention immediately.
➢ Keep the victim warm but not hot.
➢ Never feed anything to an unconscious person.
➢ Oxygen should be administered by authorized personnel only.
Waste Disposal
Fully cured printed models can be disposed of as ordinary office trash. However,
special care is required when handling printer waste (uncured printing material).
Printing Materials
➢ When removing the waste container from the printer, wear neoprene or nitrile
➢ To prevent liquid waste from splashing into the eyes, wear safety goggles.
➢ Liquid waste from the printer is classified as hazardous industrial waste.
➢ Empty Model-material and Support-material cartridges contain residue of
➢ Do not attempt to reuse empty cartridges, and do not puncture them.
➢ Dispose of used cartridges and waste containers in accordance with local
➢ Discard contaminated clothing, shoes, empty containers, etc., in accordance
UV Lamps
UV lamps used by the printer to cure printing materials contain a small amount of
mercury, and are considered "Universal Waste." Recycle or discard used lamps
in accordance with applicable regulations.
Broken lamps:
After ventilating the area, use protective gloves and carefully remove spilled
mercury with a method that prevents the generation of mercury vapor, such as a
syringe, packing tape or paper. Place the broken lamp, mercury and
contaminated materials in an air-tight, non-metallic container. Dispose of the
container in accordance with applicable regulations.
DOC-17001 Rev. L
cardiopulmonary resuscitation.
gloves.
Therefore, printing-material waste must be packaged and disposed of in a
manner that prevents human contact with it and contamination of water
sources.
their contents. Some leakage of this residue may occur through the broken
cartridge seal. Therefore, handle and store empty cartridges with care.
regulations.
with any applicable regulations.
2 Safety
2-9
Advertisement
Table of Contents
