Security Bezel Replacement; Remove The Security Bezel - Lenovo ThinkSystem SR665 V3 User Manual

b. Lower the backplane into the drive cage so that the holes in the backplane pass through the
pins on the drive cage, and press the backplane into position. The release latches will secure
the backplane in place.
Step 3. Install the rear drive cage.
Figure 99. Installing the 4 x 2.5-inch rear drive cage
a. Align the rear drive cage with the chassis, and lower the drive cage into the chassis.
b. Move the rear drive cage forward until it clicks into position.
Step 4. Connect cables to the drive backplane. See
After you finish
1. Reinstall the drives or drive fillers into the rear drive cage. See
2. Complete the parts replacement. See

Security bezel replacement

Follow instructions in this section to remove and install the security bezel.
• "Remove the security bezel" on page 137
• "Install the security bezel" on page 138

Remove the security bezel

Follow instructions in this section to remove the security bezel.
About this task
Attention: Read "Installation Guidelines" on page 39
that you work safely.
Watch the procedure
A video of this procedure is available at YouTube:
DR4X1YAcp9wFKhwj_tLQ5Y
Chapter 6 "Internal cable routing" on page
"Complete the parts replacement" on page
and
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Install a hot-swap drive" on page
"Safety inspection checklist" on page 40
.
Chapter 5 Hardware replacement procedures
167.
78.
164.
to ensure
137