Typography; Instructions; List Items; Position Numbers - Weber CCI 303 Operating Instructions Manual

1.4 Typography

The typography describes which means are used to present and explain the technical
information in these operating instructions.

1.4.1 Instructions

Instructions are marked by a hyphen, e. g.:
– Tighten screw.

1.4.2 List items

List items are marked by a point, e. g.:
• 6 Hygiene screws
• 1 toggle screw

1.4.3 Position numbers

Components are marked in figures with grey numbers and position lines. Position lines indicate
the component by means of an arrow or a point.
Fig. 5 Disassemble pin screws

1.5 Displays

Centered texts in another font refer to a notice on the display of the control unit MPS 3.
Example:
MPS 3
READY FOR
OPERATION
1.5.1

Keys

Keys are shown in brackets and in upper case letters, e. g.: Key
[ENTER]
Operating instructions Interleaver
0006
In the text, reference is made with bold
numbers to the individual items of the
components of a figure.
Figures are provided with numbers to
which reference is made in the text.
See the following example:
– Remove pin screw (2) (Fig.
5).
General
6