Removing, Installing, And Setting The Cutting Edge; Removing The Vertical Cutting Edge - Weber CCI 303 Operating Instructions Manual

7.5 Removing, installing, and setting the cutting edge

In order to avoid unnecessary contamination and unnecessary wear of the interleaver cutting
edge, this cutting edge must be removed in case of longer cutting cycles without selected
interleaver and replaced with a special interleaver cutting edge with a roller.
The product is cut by the knife at the cutting edge (two-part, horizontal and vertical). In order
to better guide the product, a product-specific form shell (one-piece) can be used instead of
the cutting edge. It is adapted to the caliber or the contour of the product. Before removing the
horizontal cutting edge, the vertical cutting edge must be removed. After replacement, the
cutting edge or the mold shell must be set correctly.
NOTE!
For work on the cutting edge, the knife protection must be placed on the knife
or the knife must be removed (see chapter "Changing the knife" in the cutting
line instructions).
7.5.1

Removing the vertical cutting edge

Fig. 46
Loosen the hexagon screw 1 with a tool by
turning to left and pull the vertical cutting
edge 2 to the right off the guide rods 3 (Fig.
46).
If a mold shell is used, there is no vertical
cutting edge. The guide rods reach into the
mold shell.
Operating instructions Interleaver
0046
Operation
46