Faults; Fault Table On The Touch; Fault Table Mps3 - Weber CCI 303 Operating Instructions Manual

9 Faults

NOTE
If a fault occurs in connection with the interleaver, the line must be switched
off immediately. Further operation may only take place after checking and
rectifying the fault.

9.1 Fault table on the touch

Fault
1. Interleaver 1. Paper transport disrupted or
paper jam paper collides with product
stack
2. Paper end,
interleaver
2. Less than 5 layers of paper on
3. Fault,
the paper roll
interleaver
cutting edge 3. Locking bolts on the paper guide
of the cutting edge not properly
closed

9.2 Fault table MPS3

Fault
1. Paper jam 1. Paper transport disrupted or
paper collides with product
stack
2. Paper shortage
2. Less than 5 layers of paper on
3. Error cutting
the paper roll
edge
3. Locking bolts on the paper guide
of the cutting edge not properly
closed
Cause of fault
Cause of fault
Operating instructions Interleaver
0052
Troubleshooting
1. Check paper course and
remedy paper jam
2. Insert new paper roll
3. Check locking bolts on the paper
guide of the cutting edge and
engage fully
Troubleshooting
1. Check paper course and
remedy paper jam
2. Insert new paper roll
3. Check locking bolts on the paper
guide of the cutting edge and
engage fully
Faults
52