7.4.4
Setting up the distance of the paper halves
Fig. 45 Distance of paper halves
–
Set the paper distance at the half-shell (1) of the 90° deflection in the interleaver housing
–
Loosen the locking screws (2) with suitable tools by turning to the left
–
Set the desired distance by turning the threaded pins (3) using suitable tools.
–
Secure the settings by turning the locking screws to the right
NOTE
When setting the paper distance, ensure a parallel course of the half shell
and the guide shaft of the "90° deflection!"
Operating instructions Interleaver
0045
To set up the distance between the two
paper halves, settings must be made on the
half-shell of the 90° deflection.
Operation
45