7.5.2
Removing the horizontal cutting edge/interleaver cutting edge
Fig. 47
7.5.3
Installing the horizontal cutting edge/interleaver cutting edge
Fig. 48
Loosen the hygiene screws 1 on the
underside of the cutting edge carrier 2 with
tools by turning to the left. When using a
mold shell, it must be pushed out of the
guide rods 3 (A) sideways. Remove the
cutting edge 4 and/or mold shell upwards
(B) (Fig. 47).
Position a new cutting edge 1 or mold shell
with centering pins on the cutting edge
carrier 2 (A) and align flush left with the
cutting edge carrier (B). Loosen the hygiene
screws 3 on the underside of the cutting edge
carrier with tools by turning to the right (Fig.
48).
Operating instructions Interleaver
0047
Operation
47