Parameters Set End Of Feed, Interleaver - Weber CCI 303 Operating Instructions Manual

7.1.1.4 Parameters Set end of feed, interleaver

Fig. 6 End of interleaver feed
–
–
Special
–
–
–
This parameter is used to set the end of the
interleaver feed. This means that the knife
position is specified, in which the interleaver
must stop the paper feed at the latest. Here, the
angle in which the knife stands is stated,
shortly before it starts cutting the paper.
Setting takes place in degrees (°)
Select [Product Parameters] button.
Select menu [Special].
Select parameter "End of interleaver feed."
Increase or reduce the value with the button [
The value is adopted.
Operating instructions Interleaver
0019
Operation
or ].
19