7 Operation
7.1 Setting the parameters
In order for the interleaver to work as desired, the parameters for fine tuning must be set via
the control of the slicer. Depending on the equipment, the slicer is equipped with an MPS3
control or a touch screen control.
NOTE
The respective menu navigation is described in detail in the operating
instructions of the cutting line and in its parameter description.
7.1.1
Brief description of the parameter settings on the touch screen
7.1.1.1 Parameters Setting the interleaver paper length
–
–
Special
–
–
–
Fig. 3 Paper length interleaver
Select [Product Parameters] button.
Select menu [Special].
Select "Interleaver paper length" parameter.
Increase or reduce the value with the button [
The value is adopted.
Operating instructions Interleaver
0016
This parameter sets the length of the paper
sheets that separate the individual slices.
The entered paper length is conveyed by
the interleaver and cut off by the knife. In
setting "0," the interleaver function is
deactivated. The adjustment takes place in
millimeters (mm).
Operation
or
].
16