Parameters Start Of Feed, Interleaver - Weber CCI 303 Operating Instructions Manual

7.1.1.3 Parameters Start of feed, interleaver

Fig. 5 Start of feed of the interleaver
–
–
Special
–
–
–
The start of the feed of the interleaver is set
with this parameter. The start of the feed
depends on the knife position at which the
interleaver can start to feed the paper at the
earliest. As a rule, the angle of the knife is set
in which the knife stands after it has cut off the
product. Setting takes place in degrees (°).
Select [Product Parameters] button.
Select menu [Special].
Select parameter "Start of interleaver feed."
Increase or reduce the value with the button [
The value is adopted.
Operating instructions Interleaver
0018
Operation
or ].
18