Checking The Course Of The Paper - Weber CCI 303 Operating Instructions Manual

7.2.2.10

Checking the course of the paper

Fig. 27 Check the course of the paper
– Perform a visual inspection of the paper course at the "90° deflection."
– In the event of an improper course of the paper, check the alignment of the paper
roll on the roller mount and the alignment of the paper on the cutting edge.
NOTE
Check the alignment of the paper on the roller mount and in the cutting
edge and readjust if necessary.
For easy inspection of the paper course, a visual
inspection of the 90° deflection can be carried out
through the opening of the housing cover.
Here, the paper must run over the entire path at a
90° angle.
If this is not the case, then the paper must be
readjusted either in the area of the cutting edge or
on the roller mount of the paper roll.
Operating instructions Interleaver
0034
Operation
34