Brief Description Of The Parameter Settings At The Mps3 Control; Paper Length; Interleaver Waiting Time; With Sub-Sheet - Weber CCI 303 Operating Instructions Manual

7.1.2

Brief description of the parameter settings at the MPS3 control

The interleaver is operated via the keyboard of the MPS 3 control of the slicer. To do this, the
handling of the MPS 3 control must be known. See operating instructions and parameter
description of the slicer.
The following parameters are available only if an interleaver is present:

7.1.2.1 Paper length

This parameter determines the length of the applied paper inserts. Scroll
with the keys[ ] and [
PAPER LENGTH INTERL.
A value [mm] from 0 to 150 can be entered.
The input of value 0 means that the interleaver is switched off. No paper feed takes place. The
parameters "WITH SUBSHEET," "WAITING TIME INTERL.," "DEPOSIT 1st SLICE" and
"START ANGLE INTERL." are not displayed by the control.

7.1.2.2 Interleaver waiting time

Number of knife head rotations after opening the slider until the interleaver feeds the paper.
Scroll with the buttons [
WAITING TIME INTERL. [U]
A value of 0 - 50 revolutions can be entered.

7.1.2.3 With sub-sheet

This parameter determines whether a paper layer is inserted under the first slice. Scroll
with the keys[ ] and [
WITH SUB-SHEET
Select by pressing [J/+], deselect by pressing [N/-].
], until the following message appears:
] and [ ], until the following message appears:
], until the following message appears:
Operating instructions Interleaver
0021
Operation
21