Parameter Position 1. Set Slice - Weber CCI 303 Operating Instructions Manual

7.1.1.5 Parameter Position 1. Set slice

Fig. 8 Corrected
–
–
Special
–
–
–
The position of the first slice is corrected with this
parameter. This parameter is required when cutting
with the interleaver and can be necessary if, for
example, the first slice does not fall on a sheet paper
from the interleaver. By entering a negative value, the
position of the first slice to the slicer is corrected (Fig.
8). The adjustment takes place in millimeters (mm).
Fig. 7 Without correction
Select [Product Parameters] button.
Select menu [Special].
Parameter "Position 1st slice."
Increase or reduce the value with the button [
The value is adopted.
Operating instructions Interleaver
0020
Operation
or ].
20