Guiding The Paper Through The Paper Control Unit/Paper Brake; The 90° Deflection (Mono Operation) - Weber CCI 303 Operating Instructions Manual

7.2.2.4 Guiding the paper through the paper control unit/paper brake

Fig. 15 Paper control unit/paper brake
– Thread the paper after guiding through the loop channel further between the paper control
unit/paper brake (1) and the guide shafts (2) and guide it through.
7.2.2.5 The 90° deflection (mono operation)
Fig. 16 The 90° deflection
– Guide the paper (1) coming from the paper control unit/paper brake through the 90°
deflection (2)
– Place the paper over the 90° deflection and guide it out of the interleaver housing
below the guide shaft (3).
Operating instructions Interleaver
0027
A negative pressure is exerted on the paper
at the paper control unit/paper brake.
This negative pressure allows a safe
guidance of the paper and keeps it
tensioned at varying feed speeds.
The negative pressure or braking force is
set via a compressed air throttle inside the
interleaver housing.
The paper is guided in the direction of the
cutting edge or the cutting head housing via
the 90° deflection.
Operation
27