Repeating A Previous Experiment With Minimal Clicks - Merck Millipore CellASIC ONIX2 User Manual

8.3 Repeating a Previous Experiment with Minimal Clicks

8.3.1 Create Experiment File Based on a Previous Experiment
8.3.2 Run Plate Setup Sequences
8.3.3 Edit Experiment Information
8.3.4 Run the Experiment
20202092 04/19
1. Click New experiment based on previous on the opening screen or
File menu.
2. In the file browser find your previous experiment and click Open.
1. On the Manual Mode tab you may click Run cell loading sequence and
wait for cell load sequence to complete.
1. Click Plate Layout to go to the Plate Layout tab.
2. Enter plate barcode (not required, but recommended).
3. Edit any plate layout information that is new for this experiment.
A C
Figure 35. Protocol editor
1. Click Run to go to the Run tab.
2. Click Start Run to open the final Pre-run Check dialogue.
3. Click Save to save your experiment.
4. Click Run.
45 of 60
B
CellASIC ONIX2 Microfluidic System
®