Icom IC-905 Advanced Manual page 159

11
D-STAR OPERATION (ADVANCED)
Entering new information into the repeater list
D Entering new information into the repeater list
Step 6. Entering the gateway repeater call sign
L This item is displayed when Step 2. Selecting the
communication type is set to "DV Repeater" or "DD
Repeater"
L The 8th digit in the call sign, entered in Step 5. Entering
the repeater call sign is automatically set to "G" as the
gateway port, so you can skip this setting and go to the
next item
1 Touch "GW CALL SIGN"
2 Enter a gateway repeater call sign of up to 8
characters, including spaces
• Only a space or "G" can be entered in the 8th digit
3 After entering, touch [ENT]
Step 7. Entering the Gateway IP address
L This item is displayed when Step 2. Selecting the
communication type is set to "DD Repeater"
1 Touch "GW IP ADDRESS"
2 Enter the IP address
• Range: 0001 ~ 255255255254
3 After entering, touch [ENT]
Step 8. Changing the repeater group
L The repeater group that is selected in Step 1. Selecting
the repeater group is displayed You can skip this setting
and go to the next item To change the group, follow the
steps, described below
1 Touch "GROUP"
2 Touch the repeater group (01 ~ 50)
Step 9. Setting "USE(FROM)" to be used as an
access repeater
L You can use the entered repeaters as an access
repeater when using the DR function When not using
as an access repeater, select "NO," and go to Step 15.
Selecting the position data accuracy level In that
case, the entered repeater is not displayed in "FROM" on
the DR screen
1 Touch "USE(FROM)"
2 Touch "YES" to use the repeater as an access
repeater
Step 10. Entering the access repeater frequency
1 Touch "FREQUENCY"
2 Enter the repeater frequency
3 After entering, touch [ENT]
Step 11. Selecting the Duplex direction
L This item is displayed when Step 2. Selecting the
communication type is set to "DV Repeater" or "FM
Repeater"
L "DUP–" is automatically set when the access repeater
frequency is entered in Step 10. Entering the access
repeater frequency If necessary, you can change the
Duplex direction
1 Touch "DUP"
2 Touch a Duplex direction
• OFF: Turn the duplex function OFF
• DUP–: The transmit frequency shifts down from the
receive frequency by the offset amount.
• DUP+: The transmit frequency shifts up from the
receive frequency by the offset amount.
Step 12. Entering the frequency offset
L This item is displayed when Step 2. Selecting the
communication type is set to "DV Repeater" or "FM
Repeater"
L The offset value* is automatically set when the access
repeater frequency is entered in Step 10. Entering
the access repeater frequency If necessary, you can
change the frequency offset.
* The default value differs, depending on the transceiver
version
1 Touch "OFFSET FREQ"
2 Enter the frequency offset
• Range: 000000 ~ 999999 MHz
3 After entering, touch [ENT]
Step 13. Setting the tone
L This item is displayed when Step 2. Selecting the
communication type is set to "FM Repeater" or "FM
Simplex"
1 Touch "TONE"
2 Touch an option
• OFF: Turn OFF the Tone function
• TONE: Select when the repeater requires an access
tone
• TSQL: Select when you want to use the tone squelch
in simplex operation
11-27