D Adjusting The Output Level; Voice Tx Set Screen - Icom IC-905 Advanced Manual

5
VOICE TX MEMORY FUNCTION
Transmitting a Voice TX memory content

D Adjusting the output level

Adjust the Voice TX memory level�
1� Display the VOICE TX screen�
» VOICE
2� Touch [TX LEVEL]�
3� Touch any Voice memory key other than [T4] or
[T8]� ([T1] ~ [T3], [T5] ~ [T7])
• The transceiver automatically transmits�
L To adjust the Transmit voice level using [T4] or [T8],
reverse steps 2 and 3�
4� While transmitting, rotate
transmit voice level�
L Pushing [DEF] for 1 second returns the value to the
default�
L Adjusting TX LEVEL too high may result in over
modulation and transmit signal distortion�
5� To save and close the VOICE TX screen, push
several times�

VOICE TX SET screen

You can set the Automatic Monitor function and the
Transmit Repeat Interval on this screen�
1� Display the VOICE TX SET screen�
2� Touch the item to set� (Example: Auto Monitor)
3� Touch the option to set� (Example: OFF)
4� To close the VOICE TX SET screen, push
TIP: You can set each item to its default by touching
the item for 1 second, and then touching "Default" on
the QUICK MENU screen�
to adjust the
Auto Monitor
Turns the Automatic Monitor function for recorded
audio content transmission, ON or OFF�
• ON: Automatically monitors transmit audio when
• OFF: Monitors transmit audio only when the Monitor
Repeat Time
Sets the repeat interval to repeat the voice
transmission� The transceiver repeatedly transmits the
recorded content at this interval�
• Set to between 1 and 15 seconds�
L Repeatedly transmits the recorded content for up to 10
minutes�
L After 10 minutes have passed, and all of the recorded
content in the memory is transmitted, the transceiver
automatically returns to receive�
5-5
» VOICE > REC/SET > SET
sending recorded audio�
function is ON�
�
(Default: ON)
(Default: 5sec)