Figure 4.20 L2 Switching > Link Aggregation > Lacp Priority Settings; Figure 4.21 L2 Switching > Link Aggregation > Lacp Port Settings - Advantech EKI-7708 Series User Manual

4.5.3.4 LACP Priority Settings
The LACP Priority Settings page allows you to configure the system priority for LACP.
To access this page, click L2 Switching > Link Aggregation > LACP Priority
Settings.
Figure 4.20 L2 Switching > Link Aggregation > LACP Priority Settings
The following table describes the items in the previous figure.
Item
System Priority
Apply
The ensuing table for LACP Information settings are informational only: System
Priority.
4.5.3.5 LACP Port Settings
Link Aggregation Control Protocol (LACP) provides a method to control the bundling
of several physical ports together to form a single logical channel. By configuring the
LACP function, the switch can negotiate an automatic bundling of links by sending
LACP packets to the peer device (also implementing LACP).
To access this page, click L2 Switching > Link Aggregation > LACP Port Settings.
Figure 4.21 L2 Switching > Link Aggregation > LACP Port Settings
The following table describes the items in the previous figure.
Item
Port Select
Priority
Timeout
Mode
Apply
EKI-7708 Series User Manual
Description
Enter the value (1-65535) to designate the LACP system priority.
Click Apply to save the values and update the screen.
Description
Select a port for the LACP Port Settings. The listed available settings
are: FE1-FE8, GE1-GE2.
However, the available settings are dependent on the connected
LACP device and may not be listed as displayed in the current figure.
Enter a variable (1 to 65535) to assign a priority to the defined port
selection.
Click the radio button to select a long or short timeout period.
Click the radio button to select the setting mode: Active or Passive.

Active: Enables LACP unconditionally.

Passive: Enables LACP only when an LACP device is detected
(default state).
Click Apply to save the values and update the screen.
49