Figure 4.21 L2 Switching > Link Aggregation > Lag Port Settings; Figure 4.22 L2 Switching > Link Aggregation > Lacp Priority Settings - Advantech EKI-9226G Series User Manual

The ensuing table for LAG Management Information settings are informational
only: LAG, Name, Type, Link State, Active Member, Standby Member, Edit (click to
modify the settings) and Clear (click to load default settings).
4.5.3.3 LAG Port Settings
The LAG Port Settings page allows you to enable or disable, set LAG status, speed
and flow control functions.
In this example we will configure a LAG between the following switches:
To access this page, click L2 Switching > Link Aggregation > LAG Port Settings.
Figure 4.21 L2 Switching > Link Aggregation > LAG Port Settings
The following table describes the items in the previous figure.
Item
LAG Select
Enabled
Speed
Flow Control
Apply
The ensuing table for LAG Port Status settings are informational only: LAG, Descrip-
tion, Port Type, Enable State, Link Status, Speed, Duplex, FlowCtrl Config and
FlowCtrl Status.
4.5.3.4 LACP Priority Settings
The LACP Priority Settings page allows you to configure the system priority for LACP.
To access this page, click L2 Switching > Link Aggregation > LACP Priority Set-
tings.
Figure 4.22 L2 Switching > Link Aggregation > LACP Priority Settings
The following table describes the items in the previous figure.
Item
System Priority
Apply
Description
Click the drop-down menu to select a predefined LAG trunk definition:
LAG 1-8.
Click the radio button to enable or disable the LAG Port.
Click the drop-down menu to select the port speed: Auto, Auto-10M,
Auto-100M, Auto-1000M, Auto-10/100M, 10M, 100M, or 1000M.
Click the radio button to enable or disable the Flow Control for the
LAG Port.
Click Apply to save the values and update the screen.
Description
Enter the value (1-65535) to designate the LACP system priority.
Click Apply to save the values and update the screen.
44 EKI-9226G Series User Manual