Management; Lldp; Figure 4.99 Management > Lldp > Lldp System Settings - Advantech EKI-7708 Series User Manual

The following table describes the items in the previous figure.
Item
Refresh period
Apply
4.9

Management

4.9.1

LLDP

LLDP is a one-way protocol without request/response sequences. Information is
advertised by stations implementing the transmit function, and is received and
processed by stations implementing the receive function.
4.9.1.1 LLDP System Settings
The LLDP System Settings allows you to configure the status (enabled or disabled)
for the protocol, set the interval for frame transmission, set the hold time multiplier
and the re-initialization delay.
To access this page, click Management > LLDP > LLDP System Settings.
Figure 4.99 Management > LLDP > LLDP System Settings
The following table describes the items in the previous figure.
Item
Enabled
LLDP PDU Disable
Action
Transmission Interval Select the interval at which frames are transmitted. The default is 30
Holdtime Multiplier
Reinitialization Delay Select the delay length before re-initialization.
Transmit Delay
Apply
The ensuing table for LLDP Global Config settings are informational only: LLDP
Enabled, LLDP PDU Disable Action, Transmission Interval, Holdtime Multiplier,
Reinitialization Delay and Transmit Delay.
Description
Click the drop-down menu to select refresh time.
Click Apply to save the values and update the screen.
Description
Click Enabled or Disabled to set the Global Settings state.
Click to select the LLDP PDU handling action when LLDP is globally
disabled. Options include: Filtered, Bridged, or Flooded.
seconds, and the valid range is 5 to 32768 seconds.
Select the multiplier on the transmit interval to assign to TTL.
Select the delay after an LLDP frame is sent.
Click Apply to save the values and update the screen.
102 EKI-7708 Series User Manual