The following figure displays the LAG Port Status settings
Figure 4.41 L2 Switching > Link Aggregation > LAG Port Status
4.5.3.4
LACP Priority Settings
The LACP Priority Settings page allows you to configure the system priority for LACP.
To access this page, click L2 Switching > Link Aggregation > LACP Priority Set-
tings.
Figure 4.42 L2 Switching > Link Aggregation > LACP Priority Settings
The following table describes the items in the previous figure.
Item
System Priority
Apply
The ensuing table for LACP Information settings are informational only: System Pri-
ority.
4.5.3.5
LACP Port Settings
Link Aggregation Control Protocol (LACP) provides a method to control the bundling
of several physical ports together to form a single logical channel. By configuring the
LACP function, the switch can negotiate an automatic bundling of links by sending
LACP packets to the peer device (also implementing LACP).
To access this page, click L2 Switching > Link Aggregation > LACP Port Settings.
Figure 4.43 L2 Switching > Link Aggregation > LACP Port Settings
Description
Enter the value (1-65535) to designate the LACP system priority.
Click Apply to save the values and update the screen.
54
EKI-7720 Series User Manual