Trouble Shooting - Rotax 914 Series Maintenance Manual

▲ WARNING: Proceed with this work only in a non-smoking area and not close
■ CAUTION:
■ CAUTION:
Once loosened, always replace self-securing nuts.
Use clean screws and nuts only and inspect face of nuts and thread for damage.
Check the contact faces and threads for damages. In case of doubt, use new
screws and nuts.
At reassembly of the engine, replace all sealing rings, gaskets, securing
elements, O-rings and oil seals.
At disassembly of the engine, mark the components as necessary to avoid any
mix-up. Take care of these marks, don't ruin them.
2.4)

Trouble shooting

In the Operators Manual, possible problems are listed. At the same time, a brief
description of the necessary remedial action is given.
See section 12 in the Operators Manual for engine type 914 (Series).
Effectivity 914 Series
Edition 1 / Rev. 0
BRP-Rotax
MAINTENANCE MANUAL
to sparks or open flames. Switch off ignition and secure engine
against unintentional operation. Secure aircraft against unau-
thorized operation. Disconnect negative terminal of aircraft
battery.
Never loosen or tighten screws and nuts with pliers but only with
the specified tools.
If during disassembling/reassembling the removal of a safety
item (e.g. safety wiring, selflocking fastener, etc.) should be
necessary, it must be always replaced by a new one.
05-00-00
page 8
May 01/2007