5.2.1)
Effectivity: 914 Series
Edition 1 / Rev. 0
BRP-Rotax
MAINTENANCE MANUAL
3
4
8
7
Cleaning the oil tank
◆ NOTE:
This procedure is optional and requires venting of the
oil system. See sec. 5.2.2.
It is only necessary to clean the oil tank and the inner
parts if there is heavy oil contamination.
-
Oil tank cleaning procedure:
-
Detach the profile clamp (2) and remove the oil tank cover (3)
together with the o-ring (4) and the oil lines.
-
Remove the inner parts of the oil tank such as the baffle insert (5)
and the partition (6).
-
Clean oil tank (8) and inner parts (5, 6) and check for damage.
■ CAUTION:
Incorrect assembly of the oil tank components can
engine faults or engine damage.
Fit drain screw (1) M12 x 12 with a new sealing ring (7)
tighten to 25 Nm (18.5 ft.lb) and safety wire.
-
Reassemble the oil tank by following the same steps in reverse
order.
2
5
05556
Fig. 32
1
6
12-00-00
page 35
May. 01/07