Oil Filter Replacement - Rotax 914 series Maintenance Manual

13.3)

Oil filter replacement

General note
At every oil change, unscrew the oil filter and cut open using special tool
taking care not to produce chips.
To carry out the procedure the following steps are necessary:
Special tool
part no. 877620*
part no. 877670*
* or equivalent
Special tool
Graphic
Fig. 27
Unscrew the oil filter.
Procedure
Step
1
Effectivity: 914 Series
Edition 2 / Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Risk of Burns!
WARNUNG WARNING
Hot engine parts!
Always allow engine to cool down to ambient tempera-
ture before start of any work.
To ensure correct functioning of the oil circuit and the
NOTICE
WARNUNG
forced flow lubrication, use genuine ROTAX oil filter
only. Only these filters will ensure correct pressure in
the by-pass valve.
part number
1
Unscrew the oil filter with the oil filter wrench.
Description
(1) Oil filter wrench
(2) Cutting tool
2
Procedure
12-20-00
02734
page 56
January 01/2010