Add/Modify Hardware Setup Files; Copy Hardware Setup Files; Remove The Standard Source Files - Renesas M3A-HS19G50 Installation Manual

5

5.3 Add/Modify Hardware Setup Files

To operate the software on the M3A-HS19 CPU board, the hardware-dependent part of the M3A-HS19 must be set up.
Add or modify the M3A-HS19 hardware setting of the standard source files, which are automatically generated when you created a
new project. Following describes how to add or modify the hardware setup files.
The hardware dependent setting means the access timing setting to the external memory (flash memory and SDRAM), operating clock
setting, and cache memory setting.

5.3.1 Copy Hardware Setup Files

Copy the "HardwareSetup" directory stored in the CD-ROM into the new project workspace directory "C:¥WorkSpace¥test", created
in 5.1.
The explanation given below assumes that the hardware setup files are stored in "C:¥WorkSpace¥test¥HardwareSetup" directory.

5.3.2 Remove the Standard Source Files

(1) Select [Project] -> [Remove Files...].
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Creating and Running a New Project Workspace
Figure 5.3.1 Remove Files (1/2)
5.3 Add/Modify Hardware Setup Files
5-9