Table of Contents
Advertisement
4
(e) If an appropriate driver is not set up, the following dialog box will appear.
4.1.4 How to Download the Sample Software
This section describes how to download the load module of the sample software.
Download the load module in the M3A-HS19 external flash memory.
For details about flash memory download settings, refer to the "SuperH Family E10A-USB Emulator User's Manual."
(1) Set up the flash memory download function
From [Setup] menu-> [Emulator] ->[System...], open [Configuration] dialog box and then [Loading flash memory] tab.
For "File Name", specify the flash memory download program "fmtool_hs19.mot". The sample workspace shall have the flash
memory download program in the following directory.
"C:¥WorkSpace¥Sample_software¥fmtool_hs61¥fmtool_hs19.mot"
As shown in Figure 4.1.14, select "Enable" for Loading flash memory. Check "File name", "Bus Width of Flash Memory" and
"Entry point" are set as shown below, and then click "OK".
Notes:
Check the setting of "Loading flash memory" every time the E10A-USB emulator is attached.
The writing module erases execute the sector erase of the flash memory in the fmtool_hs19.mot. Select
"Disable" for the "Erasing flash memory".
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Figure 4.1.13 [Unable to restore the previous driver setting] Dialog box
Figure 4.1.14 [Configuration] Dialog Box
Executing the Software
4.1.4 How to Download the Sample Software
4-7
Advertisement
Table of Contents
