How To Set Up The Flash Memory Download; Set Up The Flash Memory Download - Renesas M3A-HS19G50 Installation Manual

Sh7619 cpu board

Table of Contents

5.2 How to Set Up the Flash Memory Download

This section describes how to set up the M3A-HS19 external flash memory download program.

In this manual, we use the flash memory download program stored in the "C:¥WorkSpace¥Sample_software¥fmtool_HS19"

directory.

For details about flash memory download settings, refer to the "SuperH Family E10A-USB Emulator User's Manual."

(1) Set up the flash memory download function

From [Setup] menu -> [Emulator] -> [System...], select the [Configuration] dialog box, and open [Loading flash memory] tab. For

[File name], specify the flash memory download program "fmtool_hs19.mot" The sample workspace shall have the flash memory

download program in the following directory.

"C:¥WorkSpace¥Sample_software¥sh7619_sample¥fmtool_hs19 "

Set up "Loading flash memory", "File name", "Bus width of flash memory" and "Entry point" as shown in Figure 5.2.1 and Table 5.2.1.

Then click "OK".

Note: Check the setting of Loading Flash Memory every time the E10A-USB emulator is attached.

Rev. 1.00 July 11, 2008

REJ10J1328-0100

Creating and Running a New Project Workspace

Figure 5.2.1 [Configuration] Dialog Box

5.2 How to Set Up the Flash Memory Download

Select "Enable."

(1) Specify the path to

the fmtool_hs19.mot file.

(2)Set the bus width to 16 bits.

(3) Set to H'E55FC000 for

the writing module address.

5-7

Table of Contents