Table of Contents
Advertisement
4
4.1.3 E10A-USB Emulator Connection Error Dialog
When the E10A-USB emulator does not start up, the following dialog box will appear.
(a) When the following dialog box appears and the emulator cannot be activated as the Note on the top of page 4-5, the M3A-HS19
system power may not supplied. Check the power supply of the M3A-HS19 CPU board.
(b) If the dialog box shown below is displayed, the H-UDI pins and the H-UDI port connector may not be connected correctly.
Check the connection between the H-UDI pins and the H-UDI port connector.
(c) When the following dialog box appears, the E10A-USB emulator firmware may not be set up correctly. Use the setup tool or
the license tool for device group addition to set up the firmware for the device group to use.
(d) When the following dialog box appears, the version of the firmware set up in the E10A-USB emulator may be old. Use the setup
tool to set up the appropriate version of the firmware.
Figure 4.1.12 [The version of the emulator firmware is incorrect] Dialog box
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Figure 4.1.9 [Can not find /RESET signal] Dialog Box
Figure 4.1.10 [Check the connection] Dialog Box
Figure 4.1.11 [The product currently connected] Dialog box
Executing the Software
4.1.3 E10A-USB Emulator Connection Error Dialog
4-6
Advertisement
Table of Contents
