Table of Contents
Advertisement
3
Notes
• If the version numbers shown in (b) and (c) are the same, setup of the emulator is not required. Set up the
emulator only when "-.-.--.---" is shown in (b) or the version number of (b) is older than that of (c).
• If the connected emulator does not support the SH7619 MCU, following error message will appear to terminate
the setup tool. You need to purchase a license tool for device group additions for the SH7619 to set up the
firmware.
• If the following error message appears, the host computer is not connected to the E10A-USB emulator or the
setup switch (SW1) is turned to "0". If the setup switch (SW1) is "0", set it to "1" and connect the USB cable again
• If the [Add New Hardware Wizard] appears, refer to (ii) Set up the E10A-USB emulator driver.
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Figure 3.2.10 Error Message
Figure 3.2.11 Error Message
Setting Up the Software
3.2.2 Set up the E10A-USB Emulator
3-11
Advertisement
Table of Contents
