Table of Contents
Advertisement
4
4.1 Execute the Sample Software
This product comes with a sample software for checking the hardware operation and referring for the software development.
Following describes how to download the load module of the sample software.
Note: Set DIP switches (SW4) on the M3A-HS19 CPU board as the default setting to execute the sample
software. For details on the DIP switches setting, refer to Section 3.2.2, "Switches and LEDs" in the M3A-HS19
User's Manual.
4.1.1 Prepare to Download the Sample Software
Copy "Sample_software" directory stored in the CD-ROM into the working directory of the host computer. When the
"Sample_software" directory is created with a read-only attribute, cancel the read-only attribute. Do not use double-byte characters
in the directory path. Presence of such characters may cause the wrong operation of the cross tools.
The explanation below assumes that this directory has been copied to the C:¥WorkSpace directory.
Notes:
• The High-performance Embedded Workshop and the E10A-USB emulator software must be installed to
download the load module of the sample software. (Refer to Chapter 3).
• The SuperH RISC engine C/C++ Compiler Package must be installed to modify the sample software.
4.1.2 M3A-HS19 and E10A-USB Startup (High-performance Embedded Workshop Startup)
(1) Connect the host computer and the E10A-USB emulator.
(2) Connect the M3A-HS19 and the E10A-USB emulator. (Do not turn on the power for the M3A-HS19 yet.)
(3) Select [Start] menu → [Programs] → [Renesas] → [High-performance Embedded Workshop](folder)
→ [High-performance Embedded Workshop].
(4) The [Welcome] dialog box will appear.
Select the "Browse to another project workspace" radio button and click "OK".
Note: A project workspace is a work area for user, to store projects and their configurations. A project consists of
a configuration necessary to create programs or final binary files and a set of files. For more information about
the project workspace, refer to the "SuperH RISC engine High-performance Embedded Workshop 4 User's
Manual."
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Figure 4.1.1 [Welcome!] Dialog box
Executing the Software
4.1 Execute the Sample Software
4-2
Advertisement
Table of Contents
