Table of Contents
Advertisement
3
(3) Clicking the "Setup" button (Figure 3.2.9) shows the following dialog box.
(4) Turn the setup switch (SW1) to "0", connect the USB cable again, and click "OK". The system will start setting up the emulator
firmware.
•
Do not turn off the power for the host computer or remove the USB cable while the system is
setting up the E10A-USB emulator. Such an act may cause the E10A-USB emulator to break
down.
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Figure3.2.12 Setup Tool for SH-2 E10A-USB Emulator Dialog box
Figure 3.2.13 Firmware Set Up Started
3.2.2 Set up the E10A-USB Emulator
CAUTION
Setting Up the Software
3-12
Advertisement
Table of Contents
