Table of Contents
Advertisement
4
(2) Specify the command batch file before downloading
Execute the script file "fmtool_hs19.hdc", consisting of the access timing and bus control signal settings for the M3A-HS19 flash
memory before downloading the sample software.
Open [Debug] menu -> [Debug Settings], and select [Option] tab.
Check that the items on this tab are set as shown below.
• Command batch file load timing (B): Before download of modules
• Command line batch processing (L):
"C:¥WorkSpace¥Sample_software¥sh7619_sample¥fmtool_hs19¥fmtool_hs19.hdc"
The following script file is assumed to be stored in the sample workspace.
"C:¥WorkSpace¥Sample_software¥sh7619_sample¥fmtool_hs19¥fmtool_hs19.hdc"
(3) Activate the command line window
When downloading the load module of the sample software, activate [Command Line] window to check whether the script file is
running.
Select [View] menu -> [Command Line] to check that [Command Line] window is opened.
Note: If the script file is not executed, downloading the load module into the flash memory cannot be completed.
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Figure4.1.15 [Debug Settings] Dialog Box
Executing the Software
4.1.4 How to Download the Sample Software
4-8
Advertisement
Table of Contents
