Hardware Setup; Hardware Setup When M3A-2152G52A In Use; M32100T-Ez-E Power Supply And Settings - Renesas 32176 User Manual

5. Hardware Setup

This chapter describes how to set up the hardware components necessary to use the Starter Kit.
Table 5.1 and Table 5.2 show how to set up the hardware components.
Table 5.1 Hardware Setup Procedure
Setup Procedure
Set the emulator
Connect the host PC and emulator
Set the evaluation board
Connect the evaluation board and
emulator
Turn on the emulator
Turn on the evalution board
Table 5.2 Hardware Power Off Procedure
Setup Procedure
Turn off the evaluation board.
Turn off the emulator.
5.1

Hardware Setup when M3A-2152G52A in Use

5.1.1

M32100T-EZ-E Power Supply and Settings

The following shows how to set M32100T-EZ-E.
For more details, refer to M32100T-EZ-E User's Manual.
M32100T-EZ-E is supplied power from the host PC via USB cable, and it turns ON by connecting
included USB cable.
The Connecting M32100T-EZ-E and Host PC is shown in Figure 5.1
Figure 5.1 Connecting M32100T-EZ-E and Host PC
REJ10B0224-0310/Rev.3.10
When connected to the emulator
M3A-2152G52A M3A-2152G52
1st (Refer to 5.1.1) 1st (Refer to 5.2.1)
2nd (Refer to 5.1.1) 2nd (Refer to 5.2.2)
3rd (Refer to 5.1.2) 3rd (Refer to 5.2.3)
4th (Refer to 5.1.3) 4th (Refer to 5.2.4)
5th (Refer to 5.1.4) 5th (Refer to 5.2.5)
6th (Refer to 5.1.4) 6th (Refer to 5.2.5)
When connected to the emulator
1st (Refer to 5.1.4)
2nd (Refer to 5.1.4)
USB I/F
USB cable
M32100T-EZ-E
Mar. 2008
Starter Kit User's Manual M3A-2152
When using the evaluation
board by itself
M3A-2152G52A/M3A-2152G52
—
—
1st (Refer to 5.3.1)
—
—
2nd (Refer to 5.3.2)
When using the evaluation
board by itself
1st (Refer to 5.3.2)
—
Connect to the host
PC's USB port
32176 Group
Page 12 of 83