Hardware Setup For Development Support Tool - Renesas RA6 Series Quick Start Manual

Renesas RA Family

6. Hardware Setup for Development Support Tool

By downloading and writing a sample project that is compatible with the Renesas Motor Workbench, a motor
control development support tool, to the CPU board, you can control motor using Renesas Motor
Workbench. This chapter explains how to setup the hardware. For details on how to actually control the
motor using Renesas Motor Workbench, please refer to the application note attached to the downloaded
sample project and the manual of Renesas Motor Workbench.
Connect this product to your PC as shown below.
(1) Connect the communication board and CPU board with communication cable
Connect CN5 on the communication board and CN10 on the CPU board with the communication
cable included in this product.
(2) Connect the USB cable
Connect the USB type-C connector CN3 on the communication board to your PC with the USB
cable included with this product.
(3) Supply power
Supply DC12~48V to J1 or CN1 on the inverter board. In this section, power is supplied to J1 using
an AC adapter. Note the polarity of the power supply. J1 is center positive.
R12QS0047EJ0100 Rev.1.00
August 18, 2021
Figure 6-1 Hardware Configuration
MCK-RA6T2 Quick Start Guide
Page 16 of 18