Table of Contents
Advertisement
3
(1) Open the sliding switch cover and check that the switch (SW1) for setting the emulator is turned to "1".
(2) Select [All Programs] -> [Start] -> [Renesas High-performance Embedded Workshop] -> [Tools] ->
[Setup Tool for E10A-USB Emulator] -> [SH-2 Device Group]. A setup tool for the E10A-USB emulator will start up.
(a) Device group of the emulator firmware: Shows the name of the device group currently set
(b) Version number of the emulator firmware: Shows the version number of software for controlling the SH2 group in the emulator
(c) Version number of the setup program: Shows the version number of the setup program
Note: The version number shown in the dialog box depends on the version that the E10A-USB emulator supports.
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Figure 3.2.9 E10A-USB Emulator Setup Tool
Setting Up the Software
3.2.2 Set up the E10A-USB Emulator
3-10
Advertisement
Table of Contents
