Table of Contents
Advertisement
3
3.2.2 Set up the E10A-USB Emulator
(i) Set up New Firmware
This section explains how to set up the E10A-USB emulator firmware for the first time.
When the installed E10A-USB emulator firmware supports the SH-2 device group, skip this step and go to paragraph (ii) "Set up the
E10A-USB Emulator Driver".
To setup the firmware, follow the on-screen instructions to change the DIP switches on the E10A-USB emulator. Figure 3.2.8 shows
the DIP switches on the E10A-USB emulator.
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Figure 3.2.8 DIP switches
Setting Up the Software
3.2.2 Set up the E10A-USB Emulator
3-9
Advertisement
Table of Contents
