Table of Contents
Advertisement
3
(5) When the following dialog box appears, the E10A-USB emulator setup is completed.
(6) When the E10A-USB emulator setup has been completed, the following message will appear.
Turn the setup switch (SW1) to "1", connect the USB cable again, and click "OK".
Note: Be sure to turn the SW1 to "1" except when using the setup tool.
(7) The following dialog box will appear again. Check if it is the latest version of the firmware, and click [Exit]. The new firmware
setup is now completed.
Note: The version number shown in the dialog box depends on the version that the E10A-USB emulator
supports.
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Figure 3.2.14 Setup Completed
Figure 3.2.15 [Setup Tool for SH-2 E10A-USB Emulator] Dialog box
Figure 3.2.16 E10A-USB emulator setup tool (Completed)
Setting Up the Software
3.2.2 Set up the E10A-USB Emulator
Version numbers
3-13
Advertisement
Table of Contents
