Table of Contents
Advertisement
5
(1) File name
fmtool_hs19.mot
5.2.2 Specify the Command Batch File Before Downloading
Execute the script file (fmtool_hs19.hdc), consisting of the access timing and bus control signal settings for the M3A-HS19 flash
memory before downloading the flash memory download program
Open [Debug] menu → [Debug Settings] dialog box, and select [Option] tab.
Set up the items on this tab as shown below.
• Command batch file load timing (B): Before download of modules
• Command line batch processing (L): "C:¥WorkSpace¥Sample_softwawe¥sh7619_sample¥fmtool_hs19¥fmtool_hs19.hdc"
Note: The "Download modules after build" checkbox is selected as default. However, clear this checkbox, and select "Reset
CPU after download module", as shown above.
5.2.3 Activate the Command Line Window
Select [View] menu → [Command Line] to open the [Command Line] window.
When downloading the load modules, activate the [Command Line] window to check whether the script file is executed.
Note: If the script file is not executed, downloading the load modules into the flash memory cannot be completed.
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Table 5.2.1 Registered Data of Erasing and Writing Module Information
(2) Bus width of flash
memory
16-bit
Figure5.2.2 [Debug Settings] Dialog Box
Creating and Running a New Project Workspace
5.2.2 Specify the Command Batch File Before Downloading
(3) All erasing module
address
-
(4) Writing module
address
H'E55FC000
5-8
Advertisement
Table of Contents
