Table of Contents
Advertisement
Quick Links
To our customers,
st
On April 1
, 2010, NEC Electronics Corporation merged with Renesas Technology
Corporation, and Renesas Electronics Corporation took over all the business of both
companies. Therefore, although the old company name remains in this document, it is a valid
Renesas Electronics document. We appreciate your understanding.
Issued by: Renesas Electronics Corporation (http://www.renesas.com)
Send any inquiries to http://www.renesas.com/inquiry.
Old Company Name in Catalogs and Other Documents
Renesas Electronics website:
http://www.renesas.com
st
April 1
, 2010
Renesas Electronics Corporation
Advertisement
Table of Contents
Related Manuals for Renesas M3A-0040
Summary of Contents for Renesas M3A-0040
- Page 1 On April 1 , 2010, NEC Electronics Corporation merged with Renesas Technology Corporation, and Renesas Electronics Corporation took over all the business of both companies. Therefore, although the old company name remains in this document, it is a valid Renesas Electronics document. We appreciate your understanding.
- Page 2 Renesas Electronics. Renesas Electronics shall not be in any way liable for any damages or losses incurred by you or third parties arising from the use of any Renesas Electronics product for an application categorized as “Specific”...
- Page 3 R8A66597FP Utility Board M3A-0040 Instruction Manual Rev.1.00 2006.11...
- Page 4 Please be sure to implement safety measures to guard against the possibility of physical injury, and injury or damage caused by fire in the event of the failure of a Renesas product, such as safety design for hardware and software including but not limited to redundancy, fire control and malfunction prevention, appropriate treatment for aging degradation or any other applicable measures.
-
Page 5: Table Of Contents
M3A-0040 Instruction Manual (English) Power Cable Power cable for VBUS supplying as host function The R8A66597FP comes with “USB Sample Firmware” for evaluation. For details, please contact Renesas Technology, your distributor, or check the information on the homepage below. Renesas Technology Homepage: http://www.renesas.com/... -
Page 6: Summary
Summary The M3A-0040 is an evaluation board for the Renesas Hi-Speed USB ASSP R8A66597FP. Two USB-A receptacles are mounted on the board for evaluation of USB host operations using USB port0 and USB port1 of R8A66597. CN1 can be used for evaluation of USB peripheral operations. Please refer to the data sheet “USB2.0 Dual Function Controller R8A66597FP”... -
Page 7: Connector Description
Connector Description Connectors CN2 and CN3 provide all bus interface pins of the chip, such as processor bus interface and DMA interface. Therefore, these pins provide the same pin characteristics of the R8A66597FP such as electric characteristic, I/O direction, and functions except for the signal with *. The following table shows the pin number and function correspondences. -
Page 8: Jumper And Switch Setting
Jumper and Switch Setting JP Number Function Factory Settings Connecting between frame ground of CN5 and signal ground. Shorted by It is necessary to cut JP1’s pattern when dividing frame ground and signal ground. pattern JP Number Function Factory Settings Jumper for measurement of 3.3V current. -
Page 9: Setup
(3) VBUS output for host function Apply 5V to CN4 of the M3A-0040 board using the power supply cable included. The red wire is 5V and the black one is GND. (a) When output VBUS to CN1: Set high level output to VBOUT0 pin of the R8A66597 by software. -
Page 10: Using With Other Boards
(3) The R8A66597FP generates a core power 1.5V from VCC 3.3V. An internal regulator makes 1.5V from 3.3V through the #19-pin and #20-pin of CN3 and outputs 1.5V to VDD pin. On the M3A-0040, 4.7uF and 0.1uF capacitors are mounted as smoothing capacitors for VDD. - Page 11 Multiplex bus mode Switch SW1 of the M3A-0040 board to “MULT” when using as multiplex bus mode. Use D1/AD1-D7/AD7 of CN2 as address line share with data line. Keep open A1-A6 of CN3. Use #21-pin (A7/ALE) of CN3 as ALE.
- Page 12 USB peripheral device USB peripheral device M3A-0040 R8A66597FP DC power Target Board supply Figure 2. Target Board Connection Illustrator 2.54mm 2.54mm Figure 3. Pin Pitch of Connectors CN2 and CN3 unit: mm 80.00 60.96 11.26 Figure 4. Pin Direction of Connector CN2 and CN3 (Top View)
- Page 13 Table 1. M3A-0040 CN2 Pin Assignment 16-bit-sepa *1 16-bit-multi *2 16-bit-sepa *1 16-bit-multi *2 D7/AD7 D6/AD6 D5/AD5 D4/AD4 D3/AD3 D2/AD2 D1/AD1 Not Available Not Available Not Available Not Available WR1_N WR1_N VBUS VBUS EXIOVcc EXIOVcc EXIOVcc EXIOVcc Table2. M3A-0040 CN3 Pin Assignment...
-
Page 14: Appendix 1 Parts List
Appendix1: Part List Renesas Solutions Corporation Drawing No. Title M3A-0040 Rev.B PPL-M3A-0040-A Component Name Component Specification Notes Qty/set Product Number Mount/ Type Symbol on Board Manufacture (specification) unmount USB Socket-A CN1,CN5 UBA-4R-D14T-1(LF)(SN) Header 25X2 CN2,CN3 FFC-50BSM1B Honda Tsushin Kogyo Header... - Page 15 Test Pin (SMD) TP6,7,8,9,10(GND) HK-5-G (black) MAC8 Test Pin (SMD) TP5,14(Vbus_0,_1) HK-5-G (blue) MAC8 Test Pin (SMD) TP13(VIF) HK-5-G (green) MAC8 Test Pin TP11,12 ST-1-1 MAC8 unmount Test Pin (SMD) TP4,15(VDD1,2) HK-5-G (brown) MAC8 Jumper Socket JS-1 MAC8 for JP4,6 PPL-M3A-0040-A (2/2)
-
Page 16: Appendix 2 Circuit Diagram
0 . 0 1 u F 0 . 0 1 u F 0 . 0 1 u F 0 . 0 1 u F 0 . 0 1 u F 0 . 0 1 u F 0 . 0 1 u F M3A-0040 Rev.B... - Page 18 First edition issued R8A66597FP Utility Board M3A-0040 Instruction Manual Nov.16.‘06 © 2006. Renesas Technology Corp. and Renesas Solutions Corp., All right reserved. Printed in Japan. No reproduction without permission. Reproduction or publication of part of or entire content of this document in any form, without express permission by the publisher, is strictly prohibited.
Need help?
Do you have a question about the M3A-0040 and is the answer not in the manual?
Questions and answers