Table of Contents
Advertisement
3
(ii) Set up the E10A-USB Emulator Driver
Following describes how to set up the E10A-USB emulator driver.
The setup procedure described below is for the Windows XP.
Note: Following dialog boxes appear when the E10A-USB emulator driver is set up for the first time or when the
emulator is connected for the first time after the USB port on the host computer is changed. It may take some
time to appear the dialog box.
(1) [Welcome to the Found New Hardware Wizard] is activated.
Select the "Install from the list or specific location (Advanced)" radio button, then click "Next".
(2) Select the "Search for the best driver in these locations" radio button and tick the "Search removable media (floppy,
CD-ROM...)" checkbox. Then click "Next".
Rev. 1.00 July 11, 2008
REJ10J1328-0100
Figure 3.2.17 Found New Hardware Wizard (1/3)
Figure 3.2.18 Found New Hardware Wizard (2/3)
Setting Up the Software
3.2.2 Set up the E10A-USB Emulator
3-14
Advertisement
Table of Contents
