Hardware Setup For Development Support Tool - Renesas MCK-RX26T Quick Start Manual

Renesas RX Family

6. Hardware Setup for Development Support Tool

By downloading and writing a sample project that is compatible with the Renesas Motor Workbench, a motor
control development support tool, to the CPU board, you can control motor using Renesas Motor
Workbench. This chapter explains how to setup the hardware. For details on how to actually control the
motor using Renesas Motor Workbench, please refer to the application note attached to the downloaded
sample project and the manual of Renesas Motor Workbench.
Connect this product to your PC as shown below.
(1) Connect the inverter board and CPU board
Connect CN3,CN4 on the inverter board and CN2,CN3 on the CPU board. Connect CN2 on the
inverter board with the Motor's cable.
(2) Connect the USB cable
Connect the USB type-C connector CN9 on the CPU board to your PC threw the USB isolator.
(3) Supply power
Supply DC12~48V to J1 or CN1 on the inverter board. In this section, power is supplied to J1 using
an AC adapter. Note the polarity of the power supply. J1 is center positive.
PC
USB cable
Communication
R12QS0060EJ0100 Rev.1.00
May 23, 2023
CPU board
cable
Figure 6-1 Hardware Configuration
MCK-RX26T Quick Start Guide
Motor
Inverter board
AC adaptor
Page 16 of 18