Fitting An Additional Monitor; Information On Installation; Infinity Monitors - Dräger Savina 300 Instructions For Use Manual

Assembly and preparation

Fitting an additional monitor

Information on installation

Monitors can be mounted on the ventilator using
the corresponding holder.
WARNING
Risk of tipping over
If a monitor is mounted onto Savina 300, there
is a risk of tipping over.
The device combination is only permitted on
the trolley for Savina 300.
If the compact trolley for Savina 300 is used,
do not use an additional monitor.

Infinity monitors

The following monitors can be mounted and
connected to the MEDIBUS interface:
Infinity Mounting on
monitors Savina 300
Gamma With docking
station
Gamma XL
Gamma XXL
Delta With docking
station
Delta XL
Vista Mounted
directly
Vista XL
Vista 120
Kappa No
Kappa XLT
50
Prerequisites:
The instructions for use for the relevant monitor
must be observed. In particular:
– The conditions required for operation with
– Which parameters can be displayed.
Mounting an Infinity monitor on Savina 300
Prerequisites:
– The corresponding holder is mounted on
– The insertion plate is mounted on the underside
Connection to
MEDIBUS
interface
No
Yes
No
1 Pull out the locking bolt (A).
2 Push the monitor or docking station with the
Yes
Savina 300 (signal converter, cable, etc.)
Savina 300.
of the monitor or the docking station.
insertion plate into the holder.
Instructions for use Savina 300 SW 5.n
A